noharleyyet
Well-known member
182 HHT 30cal
Tipping Hammers
- Thread starter noharleyyet
- Start date
deer_shooter
Well-known member
Interesting. Dumb question(s)…
Where’d you get the tips? Just tapped in or some type of adhesive? Noticeable difference in performance?
Where’d you get the tips? Just tapped in or some type of adhesive? Noticeable difference in performance?
44hunter45
Well-known member
Miss T's 6.5 WBY RPM(1in8) loves 118 HHT and 125 HHT.
The 118HHT turned my 9 twist 264 Win Mag into a 1/2 MOA gun again.
I'm sold on 'em. I haven't figured out how to over-pressure them yet. You just keep adding powder until you get to 3600-3700fps and the groups are good. Then you stop.
IDK what I will do when I run out of RL-26 though.
The 118HHT turned my 9 twist 264 Win Mag into a 1/2 MOA gun again.
I'm sold on 'em. I haven't figured out how to over-pressure them yet. You just keep adding powder until you get to 3600-3700fps and the groups are good. Then you stop.
IDK what I will do when I run out of RL-26 though.
The tips and the little copper anvil come in the box with the bullets. You do not need adhesive, they friction fit in the HP hole. I sort out the less concentric tips for load workups and keep the best for finished loads.
turbobrick
Well-known member
My 6arc really likes the HHT and so does my 30-06, I'm really liking the design so far. Tipping them lends a kind of extra level of Zen to reloading.
New blue tips these days. I have some clear ones from the proto times. mtmuley
noharleyyet
Well-known member
I believe they're black.
mevertsen
Well-known member
I haven't tried the HHT yet. I have some 174's coming for my 3006. Truing to find a replacement for the 152. I dod work up with the 143's in my 3030 today. I think I have it dialed in. The 70HH in 243 is deadly.
slatebuilder
Well-known member
- Joined
- Jan 27, 2018
- Messages
- 621
I picked up some 95 grain HHT’s for a good price to use in my son’s 257 Weatherby. We’ll see.
Yes it is. mtmuley
deer_shooter
Well-known member
Thanks. Haven’t been on the hammer site for a while as I’ve been working through my stash on hand
std7mag
Well-known member
Nick87
Well-known member
I would be on board for that.
Steve built a rifle awhile back that used necked down 7mm RUM brass to 6.5. Called it the Ultra Cat. Can't remember specifics but it was a screamer. There are guys on the Hammer site pushing Hammers to 5000 fps with certain cartridges. mtmuley
Nick87
Well-known member
243 RUM just has a sweet ring to it.
antelopedundee
Well-known member
What's the likelihood that tipping them could make the COL just long enough to cause them not to fit in the magazine?
noharleyyet
Well-known member
Hope I'm not infringing forum protocol but here goes;
Announcing the New Hammer HHT
It has been years in the making with early on failures that led us to say that we would never make a tipped bullet. We could not make a tipped bullet that worked as well for terminal performance as the other Hammer Bullets lines. No matter what we did the tip always retarded terminal...
hammerbullets.com
Post #11 in particular
Just an example. The original Hunter in .30 cal 181 grains has a length of 1.587. The HHT in 182 grains has a length of 1.582. The HHT isn't a tipped HH. The profiles are different. mtmuley
Brand new ones get the new blue tips. Eventually all of them will get the blue ones when the black runs out.
.338 Cal-210gr Hammer HHT™ - Hammer Bullets
AT THIS TIME TIPS ARE CONSUMER INSTALLED TIPPING BLOCK INCLUDED WITH EACH ORDER For you 338 caliber shooters that want to keep your trajectory fast and flat, this pure copper Hammer HHT™ is the ticket. The ability to run your 338 Win Mag over 3000 fps with a bullet that has long range low...
hammerbullets.com
noharleyyet
Well-known member
Those damn things belong on Elton John's Creedmoor...j/k I'm jealousBrand new ones get the new blue tips. Eventually all of them will get the blue ones when the black runs out.
.338 Cal-210gr Hammer HHT™ - Hammer Bullets
AT THIS TIME TIPS ARE CONSUMER INSTALLED TIPPING BLOCK INCLUDED WITH EACH ORDER For you 338 caliber shooters that want to keep your trajectory fast and flat, this pure copper Hammer HHT™ is the ticket. The ability to run your 338 Win Mag over 3000 fps with a bullet that has long range low...
