Well. That's all she wrote. Broke out the .270 1500 topped with a Vortex Diamondback HP 4-16 which has been sitting in the safe while we lived in Washington (save for a trip as a back up rifle to Wyoming ... which did see it get some use). Anyways, got my new Stocky's stock VG2 mounted up, and have been enjoying shooting it in preparation for the season.
Save for this annoying little squiggle in the optic, things have been going fine. I don't know that I have noticed it before, or if I did I just kind of didn't pay any attention to it. Super hard to explain so I attached a photo, worse at lower magnifications, noticeable as heck against a clean white target. Anyways, finally got irritated enough to call Vortex about it. After confirming that, no the scope was not mounted improperly, it's not just some Schmutz on the lens, it's most likely finishing marks, or lack there of, of any actual finishing. They even floated the idea that the windage or elevation was cranked so hard one way it was messing it up. Can't blame them, I'm sure they've seen some crazy stuff. Starting the return process tomorrow.
At this point this will be the second time this scope has gone in for service, over the course of I think 6 years. First time in it cost me from late September/early October to around late November to get back for a loose lens. This time they are saying turn around is two weeks.
Long story short, I've ordered a VX3HD 4.5-14 with the CDS-ZL windplex reticle and side focus and all that jazz. I've been looking at them, they never seem to be in stock, but when I looked today they had them, so I took it as a sign to pull the trigger.
Save for this annoying little squiggle in the optic, things have been going fine. I don't know that I have noticed it before, or if I did I just kind of didn't pay any attention to it. Super hard to explain so I attached a photo, worse at lower magnifications, noticeable as heck against a clean white target. Anyways, finally got irritated enough to call Vortex about it. After confirming that, no the scope was not mounted improperly, it's not just some Schmutz on the lens, it's most likely finishing marks, or lack there of, of any actual finishing. They even floated the idea that the windage or elevation was cranked so hard one way it was messing it up. Can't blame them, I'm sure they've seen some crazy stuff. Starting the return process tomorrow.
At this point this will be the second time this scope has gone in for service, over the course of I think 6 years. First time in it cost me from late September/early October to around late November to get back for a loose lens. This time they are saying turn around is two weeks.
Long story short, I've ordered a VX3HD 4.5-14 with the CDS-ZL windplex reticle and side focus and all that jazz. I've been looking at them, they never seem to be in stock, but when I looked today they had them, so I took it as a sign to pull the trigger.