Safe queen

[Wind Gypsy]

Pardon my ignorance, but I am curious. 30-06 > .280 Rem > .280AI > 30-280AI. Wouldn't that just be a 30-06AI?

280 Rem case has the shoulder a little forward of where 30-06, 270 case shoulders are. It's a slightly bigger case rather than a straight neck down which makes it more sad it was loaded so mildly in factory fodder as it should be the real performer of the 06 bunch with the slippery 7mm bullets.

 

[Addicting]

Remingtons want to be a Tikka when they grow up.

How about a .338-06 or a .35 Whelen?

Because, I have a Lilja 30 cal barrel that needs to be spun up. But, if I didn’t I would have been open to those.

 

[Addicting]

280 Rem case has the shoulder a little forward of where 30-06, 270 case shoulders are. It's a slightly bigger case rather than a straight neck down which makes it more sad it was loaded so mildly in factory fodder as it should be the real performer of the 06 bunch with the slippery 7mm bullets.

When you AI a 06 case the material for the shoulder mainly comes from the neck. Which makes the neck shorter than it should be. By using the 280 ai brass you get a full length neck. That allows you to have the chamber deep throated and you can load the bullets all the way out in the neck. That leaves you the whole case capacity for powder.

 

[mtmuley]

I'd keep it. I like having a big .30. mtmuley

 

[BackofBeyond]

Because, I have a Lilja 30 cal barrel that needs to be spun up. But, if I didn’t I would have been open to those.

Length and twist?

 

[Addicting]

Length and twist?

It’s a 1-9 Remington sporter contour blank at 27” if I remember right. Think I was going to finish at 24”.