reattaching antler to skull plate

[homestead]

My kid shot a spike buck and when he grabbed the antlers, one fell off. How should I reattach the antler?

 

[Gellar]

Following. I have a buck that popped an antler off when I went to turn it for pictures. I tried Jb weld and it didn’t do the trick.

 

[SD_Prairie_Goat]

Table leg method? Double ended screw that you can drill into the skull and into the antler?

 

[Nick87]

Following. I have a buck that popped an antler off when I went to turn it for pictures. I tried Jb weld and it didn’t do the trick.

Cousin up north shot one few days ago same deal.

 

[Nick87]

My kid shot a spike buck and when he grabbed the antlers, one fell off. How should I reattach the antler?

Are you just skull capping the buck? Euro?

 

[Gellar]

Table leg method? Double ended screw that you can drill into the skull and into the antler?View attachment 352788

I thought about this , my hesitation was my abilities to get the angles right. I guess I can’t screw it up any more than it already is.

 

[mevertsen]

Get a replica skull

https://www.cabelas.com/shop/en/mountain-mikes-reproductions-shed-spreader-universal-deer-skull-plate?ds_e=GOOGLE&ds_c=Cabelas%7CShopping%7CPMax%7CHunting%7CHunting%7CNAud%7CTopPerf%7CNMT&gad_source=1&gclid=Cj0KCQiAsOq6BhDuARIsAGQ4-zj_TvJhqvb9AywWJtwrJnEh8ZORoq_RvCQc5KTP-bJo36Cngv0Oe3YaAl5fEALw_wcB&gclsrc=aw.ds

 

[Nick87]

I thought about this , my hesitation was my abilities to get the angles right. I guess I can’t screw it up any more than it already is.

I would do the antler end first. Might be easier to line up angle you'll need into the cap from there.

 

[Dave N]

Super glue gel.

 

[Nick87]

Super glue gel.

Some liquid nail might do it too?

 

[Dave N]

I did one of mine with super glue. Laid it on pretty thick and it's holding.

 

[homestead]

Skull cap. Thinking about drilling a hole and running a screw from the underside of the skull into the antler.

Are you just skull capping the buck? Euro?

 

[homestead]

Thank you all for the advice. At least I've got some options.

 

[Nick87]

Skull cap. Thinking about drilling a hole and running a screw from the underside of the skull into the antler.

Yah if you could pre position the antler. I would think that would make it easier.

 

[kansasdad]

Skull cap. Thinking about drilling a hole and running a screw from the underside of the skull into the antler.

Barely oversized pilot hole in the skull, with a big washer to spread out the pressure over the skull plate, and snug the antler tight to the exterior skull.

 

[Arcola]

Skull cap. Thinking about drilling a hole and running a screw from the underside of the skull into the antler.

Do this. Drill a pilot hole and use a little epoxy on the screw.