See you also have the banish 30.
Have only used it up to 60 grains of powder and 156 grain bullet. Haven’t noticed a difference between the two at that level. 95+ grains of powder and 200+ grain bullet you might
I have the banish 30 and the banish 30 gold. The 30 gold does better at taming my Weatherby 30-378 (probably the closest rifle I have to a rum). I use the 30 in the 7” configuration. I don’t notice much difference in audible noise or recoil reduction.
I called them when I was close to the same. They said that because they are having so many suppressor getting approved they are a little behind. I think they weren’t ready for the change in ATf’s speed. Everything else for me is seamless. Just the part from approved to in my hands is frustrating.
That’s what they told me too.
Whats the advantage to a tapered mount?
Direct thread is somewhat prone to working loose during use, and is less repeatable to zero when you remove the can and put it back on. Taper mounts are really resistant to working loose, and they typically return to zero. The taper mounts I use are also a brake, they help reduce wear on the can and also continue to be a brake if the can is off. The taper mount will also protect the usually fine threads on a rifle barrel. They are more of a set it and forget it solution compared to direct thread.
If it's the industry standard HUB (1-3/8"x24tpi) direct thread adapter, you could order direct from a manufacturer. I have a Diligent Defense suppressor in the CLEO notification period right now, but I ordered their 1/2x28 DT adapter and it's only $55 and in stock in multiple barrel thread pitches.
Good to know, thanks. Just a bit bummed that I ordered it 14 months ago and now they’re telling me this while my suppressor is on the way.
Suppressor shipped today
Man they like you apparently. I was at 30 days post approval and finally called them. They said it should have shipped well before that.
You will like that ultra 7, it’s a very nice can.
