Tuning help

[Dieseldog]

I can't get this tear out of my bow.. I tried most everything but going to a stiffer spine.. Any ideas?left. Hand. 29inch Halon pulling 71lbs. Easton Fmj arrows 28.5 inch with 100grn points.

 

[JLS]

A few thoughts:

Possibly improper cam lean
Possibly hand torque
Possibly improperly timed drop away rest/fletching contact

Is this a new bow? Are you a new shooter?

I would start by checking for hand torque, and also check your bow specs and cam lean.

 

[Trial153]

shoot it without the 100 grains up front. If it clears it up you know your weak.

 

[JLS]

What spine is the arrow?

 

[Dieseldog]

340 spine on fmj. Not a new shooter. Also gonna try and switch my top hats around on the top cam. Have checked rest clearance and timing and it seems good. But gonna try a limb driven drop away next and see what happens.
.

 

[Badger_55]

I know you said you are not a new shooter but I just went through similar issues and i am far from a new shooter. Always looking to be better though. Minor tweaks to refine my center shot n throwing bare shafts through paper. Then you can look for fetching contact after. I found that I had too much hand torque. Good time of the year in northern mn to run through fundamentals in your basement. I now have good bareshaft and fletched paper holes consistently with minor changes.