Summer sausage in water to set fat?

INMT

Well-known member
Joined
Nov 27, 2023
Messages
506
Location
NW MT
I’m smoking summer sausage for the first time right now.

Some recipes I’ve read say to submerge in ice water for 10 minutes when finished to set the fat.

Others say to rest at room temperature for an hour.

What finishing method has worked best for folks?
 
After testing both I much prefer resting at room temp for a few hours then to the fridge to chill before packaging them up. Only time I still use a ice bath is if I wasn't paying enough attention and over shoot the 150 degree mark.
 
Same, ice bath, wipe off, then hang dry. It helps set the casing and you don’t get a shrivel. When I just air cool, I’ve had the casing get quite a bit of air gap from the meat. That can lead to freezer burn. If the casing stays tight they can be frozen as is for long term storage.
 
Some water chill can help with initial cooling and reduce shrink. Most home refrigerators don’t chill very quickly.

I’d water chiller early on. That way it will evaporate off the water during the remainder of cooling. This also aids chilling through evaporative cooling.
 
Another vote for ice bath. Sink full of cold water if nothing else. Helps set the sausage and bring the temp down quickly. 5-10 minutes is pretty good, then transfer to the fridge.
 
I also put them in a ice bath when they come out of the smoker, about 10 minutes or so. Wipe dry and hang in fridge 24 to 48 hrs to dry. Vacuum seal before freezing.
 
Another vote for ice bath for about 20 minutes to stop the cooking and set the fat.
Then in the fridge overnight.
Then vac seal the next day in 1# pieces of roll.
 
Back
Top