Reloading Lot, Great for beginner, 308 and 243 dies

[SD_Prairie_Goat]

Selling the lot of my reloading stuff. Haven't used it in a couple of years and just collected dust.


Can provide more info as needed, hoping to sell as a lot.

In person preferred, but willing to ship at the buyers expense.


$200



RCBS JR3 Rifle Press 77 Heavy Cast Iron single stage press

RCBS 15501 Full-Length Die Set Group A .308 Win

RCBS 9440 Bullet Puller, 243 (6mm) and 30 cal

Lee Precision 90681 Safety Magnetic Powder Scale

Lee Precision 90556 Reloading Dies - 4 Piece 308 win

Lee Precision 90556 Reloading Dies - 4 Piece 243 win

Lyman Case Prep Multi Tool

Other Misc. (basically everything you need to get started minus powder, bullets, casings, etc.)

 

[SD_Prairie_Goat]

Price reduction $200 for the lot

 

[SD_Prairie_Goat]

Bump

 

[SD_Prairie_Goat]

Bump once again

 

[SD_Prairie_Goat]

$175 for the lot

 

[Forkyfinder]

Is there a coal length limit with that press?

 

[SD_Prairie_Goat]

Is there a coal length limit with that press?

Not really sure. you install the dies and adjust the depth via the threads for where you need it and then use the locking feature of the nut to hold it in that place consistently.


Does that make sense or help?

 

[millerkiller77]

Is there a coal length limit with that press?

I dont know the exact COAL limits, but a friend of mine uses his to load 300wm.

 

[Forkyfinder]

Not really sure. you install the dies and adjust the depth via the threads for where you need it and then use the locking feature of the nut to hold it in that place consistently.


Does that make sense or help?

Mostly concerned it wont reload something CIP aics length (like 3.75") with it being a "jr"?

I would want to reload 308, 6.5 manbun, 223, and 300 prc - and just wasnt sure if this would work for the last one.

 

[SD_Prairie_Goat]

Mostly concerned it wont reload something CIP aics length (like 3.75") with it being a "jr"?

I would want to reload 308, 6.5 manbun, 223, and 300 prc - and just wasnt sure if this would work for the last one.

Not sure how to check that. I can screw down the 308 dies as low as possible and check how close it can get to the case holder? Would that help figure it out?

I only reloaded 308 and 243 which is why I'm not sure...