If you are going to move standard IRA into Roth, these are the times to do this for sure! I think it's going to get worse before it get's better though. Seems like nations need to hurt before any perceived deals will be made in the trade war.
I agree, if you have 16 points or more, you might call Josh. In my research, he has the best area and he even picked up one or two other outfits and has increased the area he hunts now. I think all outfitters in this general area had a rough time this year. Just saves more elk for next year. All...
Yes, Corey was my outfitter and guide. He did a phenomenal job and I can't say enough good about his outfit. This hunt is somewhat migration dependent though. I was the only one of three in my group that shot a bull. There was another 320 bull or two and a funky bull that I would have considered...
Another year has come and gone. It's time to evaluate this again. Has there been any changes to either platform that justify going with just one over the other. I didn't even bother with GoHunt mapping this year so I can't speak to it. I've been strictly using GoHunt for application purposes and...
I went for the hunt but the experience with horses was every bit as exciting and enjoyable. I too highly recommend every DIY hunter give it a try at some point.
Unfortunately, I was the only one in camp that did not see a griz. One day, there were seven grizzlies seen and three were a sow and two cubs strolling right through camp while I was on a hike. Another day after my harvest, I hiked from camp to grab those sheds and one of the guides who rode...
I drew a wilderness unit and wanted the full experience so I chose to hunt with Crandall Creek Outfitters. No regrets, had a blast and shot a bull. Found a bonus set of matching sheds too.
yes, using a q-tip I've also lubed the neck. I am getting scratches, more like shavings off the neck but very slight. I do not see burrs on the inside of the casing but I'll look up in the die. should I lubricate the die as well?
I'm reloading some 28 nos and using a Redding die. I've cleaned my brass and rolled them in oil to lubricate the casing. When depriming and resizing the casing, I'm getting some very slight brass shavings around the neck. I can see that the resizing component is shaving the brass. Can anyone...