turbobrick
Well-known member
This is a 6br I put together to shoot for fun at the range in between other rifles when working on load development. I've ended up barely using it, and I'm looking to build another hunting rifle so I just don't need it anymore.
This was a brand new Remington 308 that I pulled the barrel off and threaded on an Urban Rifleman 6br barrel with NSS barrel nut and recoil lug, I also have Go/No-Go gauges that are included. There are a couple marks on the receiver from the receiver wrench, just cosmetic.
I had a Badger Ordnance bolt knob installed, then I put on a Timney Elite Hunter, EGW 20 MOA base, Vortex Venom 5-25x56 FFP MOA, Griffin taper mount, MKM bubble and grip.
It's all in an Oryx chassis with a couple SRS M-lok weights and an ARCA rail, MDT 6br magazine, M-lok bag rider, and some extra LOP spacers.
Also included, 200 pieces of Lapua brass from the same lot, 100 pieces completely unfired, 30 unfired but primed, and 70 pieces once fired. These are the only rounds through the gun, all mild Varget loads with Hornady 108 eld-m. The dies are RCBS Matchmasters and Hornady shell holder.
PARTED OUT
This was a brand new Remington 308 that I pulled the barrel off and threaded on an Urban Rifleman 6br barrel with NSS barrel nut and recoil lug, I also have Go/No-Go gauges that are included. There are a couple marks on the receiver from the receiver wrench, just cosmetic.
I had a Badger Ordnance bolt knob installed, then I put on a Timney Elite Hunter, EGW 20 MOA base, Vortex Venom 5-25x56 FFP MOA, Griffin taper mount, MKM bubble and grip.
It's all in an Oryx chassis with a couple SRS M-lok weights and an ARCA rail, MDT 6br magazine, M-lok bag rider, and some extra LOP spacers.
Also included, 200 pieces of Lapua brass from the same lot, 100 pieces completely unfired, 30 unfired but primed, and 70 pieces once fired. These are the only rounds through the gun, all mild Varget loads with Hornady 108 eld-m. The dies are RCBS Matchmasters and Hornady shell holder.
PARTED OUT
Last edited:
