Best fluting for bolts
- Thread starter nhenry
- Start date
BackofBeyond
Well-known member
Spiral flutes look cooler.
noharleyyet
Well-known member
Cera coated flutes, even better.
jr young purple
jr young purple
BAKPAKR
Well-known member
@Backofbeyond is right you know.
Karl Feldcamp has done Ti bolt fluting on two of my bolts. He called me about the magnum bolt and recommended that the bottom of the bolt not be fluted if I were using a belted magnum. That was due to the possibility of the flutes catching the belt. I was having a RUM converted to a Nosler so that was not a concern.
If @noharleyyet convinces you to go with colored flutes, just don’t use @Dsnow9 pink.
And @mtmuley, spiral fluting looks neat. It would probably look really good on a new 6.5 CM.
Karl Feldcamp has done Ti bolt fluting on two of my bolts. He called me about the magnum bolt and recommended that the bottom of the bolt not be fluted if I were using a belted magnum. That was due to the possibility of the flutes catching the belt. I was having a RUM converted to a Nosler so that was not a concern.
If @noharleyyet convinces you to go with colored flutes, just don’t use @Dsnow9 pink.
And @mtmuley, spiral fluting looks neat. It would probably look really good on a new 6.5 CM.
noharleyyet
Well-known member
Coz it makes my stretchy pants tingle...
noharleyyet
Well-known member
@mtmuley flutes for we RUM snobs...black cera in the flute valleys
noharleyyet
Well-known member
Great to communicate with...a personable gentleman.Another vote for Kampfeld ti fluting. He’s done a couple of mine and I just got my wife’s 243 back (matching bolt knob of course)he does a hell of a job and turns it around quick
BackofBeyond
Well-known member
Sig line material right there.
Flutes in general or the spiral? I would say the spiral is just for looks, because in todays CNC world it is really no more work than a straight. It is possible a small amount of smoothness in rotating the bolt could come from from spiral over straight because of the distribution of surface area results in less edges aligning with the straight lines of the receiver opening.
My focus and budget is on function. No flutes for me. mtmuley
That’s what I’m asking about mainly. The function. Do the flutes make the bolt travel smoother? Does it feel less dirty?
Don't care really. In my case with what I am doing it doesn't matter. mtmuley
BAKPAKR
Well-known member
And for you ounce counters, I have read that fluting can remove from just under an ounce to 1.5 ounces. That is not much but if you save another 2 to 2.5 ounces by using a speedlock firing pin assembly with the aluminum shroud, the weight-savings starts adding up.
BenInMT
Well-known member
I think the supposed benefit is that it can shed ice or debris to keep it from getting stuck in harsh conditions? I don’t really know. Only one of mine is fluted.
Redside
Well-known member
- Joined
- Jul 13, 2016
- Messages
- 365
Got mine fluted through LRI, straight up did it for the looks. Went with the wrought iron and black cerakote. Turned out pretty good.
Don Fischer
Well-known member
- Joined
- Jun 27, 2017
- Messages
- 3,141
Find a new rrifle with flutes and try it. Then find about a 1950 Mannlicker-Shonuer ( spelled wrong) and compare the two. I have flutes on my Partiot only because it came that way. If your hurrying to jack in another round do you really believe your gonna notice smooth beyond some unknown point? Don't care for flute's on the bolt or the barrel.
Similar threads
